Globe Core TRANSFORMER OIL PURIFICATION PLANT CMM-0.6

Description

The CMM-0.6 portable oil degassing unit can be used for
oil filtration, oil pumping, oil heating, and degassing of dielectric insulating oil
, as well as removing mechanical impurities and moisture.  The processing capacity of the unit is 0.6 m3/hour.
The unit consists of the vacuum column,
ceramic oil heater
, fluid pump, vacuum pump, and oil filtering system with
replaceable cartridges
.
Sensors have been installed in the unit so that the operator can control the pressure drop at the filters and control the amount of working vacuum.  The heating temperature can also be controlled through the use of a special regulator.
When processing/treating a transformer with high moisture content in the oil, there is always a possibility of
foam formation
, therefore, in order to avoid this problem a special type of
protection
is provided for in the unit.  If, for some reason, oil begins to leak or spill from the unit, the oil spill will be immediately detected by the “
Oil Spill Sensor
” and the unit will be shut down at the same alerting the operator with an alarm.
No.
Parameter Description
Value
1
Efficiency, m3/hour
0.6
2
Power supply (AC 50Hz, V)
380*
3
Rated input power, kW
14
4
Pre-filter, micron
200
5
Degree of filtration, microns
5
6
Cleanliness level after processing (as per ISO 4406)
-/14/12
7
Oil breakdown voltage after one cycle of processing not less, kV
60**
8
Outside dimensions (excl.hoses) not more, mm
— length
750
— width
520
— height
1350
9
Weight (without oil) not more, kg
250
* – any voltage available at customer’s request
** – provided that the processed oil has not been in use.
You can purchase the CMM-0.6 degassing unit right now by contacting one of our managers on the contact list.
In order to change the default parameters to your specific needs, the Customer must fill out a questionnaire, wherein you should include the necessary technical requirements.